STA-RITE 400S Series Owner's Manual

Submersible Solids Handling Pump
Printed in U.S.A. © 2003
Carefully read and follow all safety instructions in
this manual or on pump.
This is the safety alert symbol.
When you see this symbol on your pump or in this manual,
look for one of the following signal words and be alert to
the potential for personal injury.
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The word NOTICE indicates special instructions which are
important but not related to hazards.
1. Read these rules and instructions carefully. Failure to
follow them could lead to serious bodily injury and/or
property damage.
2. Check your local codes before installing. You must
comply with their rules.
3. Vent sewage or septic tank according to local codes.
4. Do not install pump in any location classified as
hazardous by local codes.
Risk of electrical shock. Can burn
OWNER'S MANUAL
Installation • Operation • Repair Parts
Auto – 5PWS4CO7A, Non-Auto – 5PWS4CO7
STA-RITE INDUSTRIES, INC., DELAVAN, WISCONSIN 53115
SAFETY INSTRUCTIONS
400S Series
or kill. Do not lift pump by power cord. See "Cord Lift
Warning" on Page 3.
burn, or cause death. During operation the pump is
in water. To avoid fatal shocks, proceed as follows if
pump needs servicing:
5A. Disconnect power to outlet box before pulling pump
cord plug.
5B. Take extreme care when changing fuses. Do not stand
in water or put your finger in fuse socket.
5C. Do not modify cord and plug. When using cord and
plug, plug into a grounded outlet only. When wiring to
a system control, connect pump ground lead to system
ground.
6. Do not run pump dry. Dry running can overheat pump,
(causing burns to anyone handling it) and will void war-
ranty.
7. Pump normally runs hot. To avoid burns when servic-
ing pump, allow it to cool for 20 minutes after shut-
down before handling it.
8. In normal service, motor should not need oiling. Motor
has been filled at the factory with a special oil; when
overhauling, replace with new oil. Use only oil speci-
fied in parts list of this manual. Use of any other oil
could damage motor and will void warranty.
SX311 (Rev. 3/19/03)
Hazardous voltage. Can shock,