Bosch Professional LR 2 Original Instructions Manual page 22

OBJ_BUCH-821-002.book Page 22 Tuesday, December 9, 2008 4:04 PM
22 | English
Measuring tool too high: When the laser beam runs through the
bottom half of the reception area 6, the direction indicator d on the
display and the corresponding direction LED 8 light up.
When the audio signal is switched on, a fast-beat signal sounds.
Move the measuring tool downward in the direction of the arrow.
Measuring tool in centre position: When the laser beam runs
through the reception area 6 at the centre mark 7, the centre indi-
cator c on the display and the corresponding centre-indication LED
9 light up. When the audio signal is switched on, a continuous sig-
nal sounds.
Audio Signal for Indication of the Laser Beam
The position of the laser beam on the reception area 6 can be indi-
cated via an audio signal.
After the measuring tool has been switched on, the audio signal is
always set to the low volume level.
The volume level can be increased or switched off.
To change the volume level or switch off the audio signal, push the
acoustic signal button 3 until the requested volume level is indicat-
ed on the display. At low volume level, the audio signal indicator a
appears on the display with one bar; at high volume level, the indi-
cator appears with three bars. When the audio signal is set to off,
the indicator goes out.
Independent of the audio signal setting, a short beep sounds at low
volume level each time a button is pressed on the measuring tool.
1 609 929 S03 | (9.12.08) Bosch Power Tools