Download Print this page

Setting Up And Connecting; Starting Up - AEG DVD 4539 HDMI Instruction Manual

Advertisement

Available languages

Available languages

Unpacking
Setting up
Remote control
battery installation
05-DVD 4539 AEG_GB_new.indd 39
05-DVD 4539 AEG_GB_new.indd 39

Setting up and connecting

Unpack the appliance and all accessories and check that the contents
are complete.
ATTENTION:
Always transport/send the player in its original packaging to prevent
it from being damaged. Keep the packaging for this purpose. Dispose
of unnecessary packaging material in accordance with the regulations
applicable in your country.
NOTE:
Get in touch with your dealer immediately if you notice damage
caused by transport.
1. Place the player on a stable, heat resistant, horizontal and level
surface. Keep a distance of at least 10 cm from walls and objects.
2. Connect the device to a properly installed power socket.

Starting up

WARNING:
Leaking out battery acid can damage your health. Remove the battery
from the battery compartment as soon as it is exhausted or if the
remote control is not going to be used for a longer period of time.
Wipe up leaked out battery acid with a cloth. In case of skin contact
immediately wash the aff ected area. Seek medical advice if battery
acid has been swallowed.In case of contact with your eyes wash out
the eyes and seek medical advice.
ATTENTION:
Mismatching battery types or new and used batteries must never be
used together. Diff erent battery types have diff erent properties. Do
not use old and new batteries together. The mutual use of old and new
batteries can shorten the lifetime of the new batteries and possibly
result in leakage of the old batteries. When disposing of old batteries
you should strictly comply with the legal and environmental regulati-
ons applicable in your country. Do not throw batteries into fi re!
NOTE:
The lifetime of the enclosed batteries may be shortened because of
storage.
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity
(+ and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.
NOTE:
The signals from the remote control are transmitted to the DVD-Player
by infrared light. You should therefore take care that the DVD-Player is
not exposed to the direct sunlight. This could make the transmission of
signals from the remote control to the DVD-Player impossible.
English
39
26.05.2009 9:22:43 Uhr
26.05.2009 9:22:43 Uhr

Advertisement

Chapters

loading