AEG DVD 4539 HDMI Instruction Manual page 55

05-DVD 4539 AEG_GB_new.indd 55 05-DVD 4539 AEG_GB_new.indd 55
Large: The loudspeaker supports a frequency band below 200 Hz.
Small: The loudspeaker supports a frequency band above 200 Hz.
Off : The loudspeaker does not produce any audio signals.
Example:
a) The correct setting for DVDs with AC3 sound using a Scart cable for
the picture and sound data (Fig. 2/14).
Front speakers = large
Centre speaker = none
Surround speakers = none
b) The correct setting for DVDs with AC3 sound using the 5.1 audio
output (Fig. 2/13).
Front speakers = small
Centre speaker = small
Surround speakers = small
Subwoofer:
Off : The loudspeaker does not produce any audio signals.
On: The loudspeaker produces audio signals.
Test Tones
A full surround sound is produced for the test tone. The individual
loudspeakers are activated one after the other. It is therefore possible
for you to check the connection and settings of your multichannel
loudspeakers.
Center/Surround Delay
If you use a 5.1-Audio system, you may experience a distortion of the
sound impression caused by the distance diff erences between speaker
groups and listener. Sounds that should be heard by the listener at the
same time arrive successively.
Here you can delay the sounds from the central and rear loudspeakers in
order to produce a balanced sound for the listener.
Digital Output
Here you specify the settings for the digital Audio output.
Off : No digital audio signal is produced.
PCM: Output of a digital Audio signal that is converted to a 2-chan-
nel signal. Use this setting if your amplifi er is a two-channel stereo
amplifi er.
All: Output of a digital Audio signal. Use this setting if your amplifi er
is no two-channel stereo amplifi er.
NOTE:
If there is no Audio output, even though you connected the DVD-
Player to an amplifi er, you will most likely have chosen an incorrect
setting for the Audio output.
English
55
26.05.2009 9:22:46 Uhr 26.05.2009 9:22:46 Uhr