Configure The Functionality Of A Sensor - Emerson uerdant VX Series Installation Manual

Confi guring & Managing Accessories
Discovering an Active Sensor
The thermostat will display the fi rst sensor discovered in the pairing process. Ensure
that the unique device number displayed on the screen matches the unique ID found
on the sensor.
Press the F|C button to confi gure the discovered sensor.
➤
If the sensor displayed on the screen is not the correct sensor to pair with the HVAC
Controller, use the UP or DOWN buttons to fi nd other discovered sensors. To start
over, press the ON/OFF button to exit and refer back to the Accessory Confi guration
section of this manual.
30
Confi guring & Managing Accessories
Confi guring the Functionality of a Sensor
The user must confi gure the type of sensor being paired with the HVAC Controller.
Use the table below to confi gure the correct sensor functionality.
Press the F|C button to advance to the next device type;
➤
Press the UP and DOWN buttons to increase or decrease the trailing digit;
➤
Hold the F|C to save sensor settings.
➤
Sensor Type 0
OCC
Disabled
Occupancy Sensor
DS
Disabled
Door Switch
Master*
RT
Temperature Reading From
Temperature Sensor
Sensor Overrides Thermostat
*Indicates default setting.
1 2
Enabled*
N/C N/O*
Normally Closed Normally Open
Average
Average
Average of Tem-
Average of Temperature
perature Readings
Readings From All Sensors
From All Sensors &
& Thermostat
Thermostat
31