Related Manuals for Major Manufacturing HIT-66-295
Summary of Contents for Major Manufacturing HIT-66-295
- Page 1 1825 VIA BURTON ANAHEIM CA 92806 714-772-5202 / FAX 714-772-2302 EMAIL: MAIL@MAJORMFG.COM WEB: WWW.MAJORMFG.COM INSTRUCTIONS HIT-66-295 TEMPLATE YALE 8700/8800 SERIES MORTISE LOCK WHEN USING POWER TOOLS ALWAYS WEAR EYE AND EAR PROTECTION!!
-
Page 2: Think Safety
Be sure all bits and cutters are sharp and in good condition and all power tools and extension cords are in good working order and properly grounded. AND MOST IMPORTANTLY, BE SURE TO WEAR, EYE AND EAR PROTECTION. Copyright 2016—Major Manufacturing PAGE 1... - Page 3 The lack of bearing surface will cause Shown above is a spade or paddle type the bit to jam. bit. Do not attempt to use this in any drill guide. There is no bearing surface and you will jam the bit. Copyright 2016—Major Manufacturing PAGE 2...
- Page 4 NOTE: The HIT-66 clamps shown are not part of the HIT-66-295 template set and must be purchased as a separate item. Install the alignment guide to either side of the template set.
- Page 5 Start by drilling the 5/16” diameter thru bolt holes located around the spin- dle. A standard twist drill will work on both wood or steel doors. Drill to the mortise pocket from both sides of the door. Copyright 2016 Major Manufacturing Inc PAGE 4...
- Page 6 When drilling pull the hole saw out of the cut several times to clear the chips, use a low rpm. Copyright 2016—Major Manufacturing Inc PAGE 5...
- Page 7 If you are installing a rose trim, the installation is complete as seen above. If installing escutcheon trim, see the following steps. If installing thru bolted trim, use a twist drill and drill the two holes marked escutcheon. Drill half way from both sides of the door. Copyright 2016—Major Manufacturing Inc PAGE 6...
- Page 8 Completed installation using thru bolted trim. If using surface mounted trim see next step If installing on a wood door, use a 1/16” twist drill and drill the four drill bushings marked escutcheon on both sides of the door. If installing on a steel door, enlarge these holes with a #32 drill...
- Page 9 Visit our web site at www.majormfg.com for more information on lock templates and a complete listing of all the tools we have available. While there, sign up for our newsletter and we will email new product information directly to you. PAGE 8 Copyright 2016—Major Manufacturing...