Related Manuals for Major Manufacturing HIT-66-230
Summary of Contents for Major Manufacturing HIT-66-230
- Page 1 1825 VIA BURTON ANAHEIM CA 92806 714-772-5202 / FAX 714-772-2302 EMAIL: MAIL@MAJORMFG.COM WEB: WWW.MAJORMFG.COM INSTRUCTIONS HIT-66-230 TEMPLATE BEST 34H-37H MORTISE LOCK WHEN USING POWER TOOLS ALWAYS WEAR EYE AND EAR PROTECTION!!
-
Page 2: Think Safety
Be sure all bits and cutters are sharp and in good condition and all power tools and extension cords are in good working order and properly grounded. AND MOST IMPORTANTLY, BE SURE TO WEAR, EYE AND EAR PROTECTION. Copyright 2011—Major Manufacturing PAGE 1... - Page 3 The lack of bearing surface will cause Shown above is a spade or paddle type the bit to jam. bit. Do not attempt to use this in any drill guide. There is no bearing surface and you will jam the bit. Copyright 2011—Major Manufacturing PAGE 2...
- Page 4 NOTE: The HIT-66 clamps shown are not part of the HIT-66-230 template set and must be purchased as a separate item. With both clamps opened equally, install both inside and outside templates to the HIT-66 clamp as shown. Do not tighten the 10-32 screws at this time.
- Page 5 These holes go to the mortise cavity. Drill both top and bottom holes on both sides of the guide, do not try to drill from one side through to the other. PAGE 4 Copyright 2011—Major Manufacturing...
- Page 6 This is a prep for a Best mortise lock with rose trim. If installing escutcheon trim see next page. Completed lock prep. Install lock per manufacturers directions That’s all there is to PAGE 5 Copyright 2011—Major Manufacturing...
- Page 7 When all holes have been completed, remove the HIT-66 drill guide from the door. Completed lock prep. Install lock per manufacturers directions That’s all there is to If installing J trim, see next page. PAGE 6 Copyright 2011—Major Manufacturing...
- Page 8 DO NOT DRILL THE BOTTOM M&N TRIM HOLE. When all holes have been completed, remove the HIT-66 drill guide from the Completed lock prep. Install lock per manufacturers directions That’s all there is to PAGE 7 Copyright 2011—Major Manufacturing...