Related Manuals for Major Manufacturing FALCON MA Series
Summary of Contents for Major Manufacturing FALCON MA Series
- Page 1 1825 VIA BURTON ANAHEIM CA 92806 714-772-5202 / FAX 714-772-2302 EMAIL: MAIL@MAJORMFG.COM WEB: WWW.MAJORMFG.COM INSTRUCTIONS HIT-66-240 TEMPLATE FALCON MA SERIES MORTISE LOCK WHEN USING POWER TOOLS ALWAYS WEAR EYE AND EAR PROTECTION!!
-
Page 2: Think Safety
Be sure all bits and cutters are sharp and in good condition and all power tools and extension cords are in good working order and properly grounded. AND MOST IMPORTANTLY, BE SURE TO WEAR, EYE AND EAR PROTECTION. Copyright 2010—Major Manufacturing PAGE 1... - Page 3 Drill Bit Types All hole saws are not created equal. A cheap hole saw from a home improvement center or one that has been dropped can be out of round and will not fit the drill bushings in our templates. Shown above is a standard twist drill bit.
- Page 4 NOTE: The HIT-66 clamps shown are not part of the HIT-66-282 template set and must be purchased as a separate item. With both clamps opened equally, install both inside and outside templates to the HIT-66 clamp as shown. Do not tighten the 10-32 screws at this time.
- Page 5 Install the mortise lock positioning plate. The plate will fit into the 1-1/4” x 8” faceplate cut out. There will be a 3/8” diameter pin centered on the plate. There is no top or bottom to worry about. Slide the HIT-66 template with the alignment guide alignment pin and tighten to door.
- Page 6 Using a 1-1/8” hole saw, drill the hole for the lock spindle. It is drilled to the mortise cavity. If your mortise lock installation required an inside thumb turn, use a 1/2” twist drill and drill the required hole on the inside of the door only.
- Page 7 If installing escutcheon trim, the holes can be drilled with a twist drill or hole saw. The factory template calls for a 19/32” hole. Our drill guide uses a template hole size of 5/8”. Drill the escutcheon holes half way from both sides of the door.