Related Manuals for Major Manufacturing HIT-66-266
Summary of Contents for Major Manufacturing HIT-66-266
- Page 1 1825 VIA BURTON ANAHEIM CA 92806 714-772-5202 / FAX 714-772-2302 EMAIL: MAIL@MAJORMFG.COM WEB: WWW.MAJORMFG.COM INSTRUCTIONS HIT-66-266 TEMPLATE SAFLOK MT-MKO & DAJ MORTISE LOCK WHEN USING POWER TOOLS ALWAYS WEAR EYE AND EAR PROTECTION!!
-
Page 2: Think Safety
Be sure all bits and cutters are sharp and in good condition and all power tools and extension cords are in good working order and properly grounded. AND MOST IMPORTANTLY, BE SURE TO WEAR, EYE AND EAR PROTECTION. Copyright 2014—Major Manufacturing PAGE 1... - Page 3 The lack of bearing surface will cause Shown above is a spade or paddle type the bit to jam. bit. Do not attempt to use this in any drill guide. There is no bearing surface and you will jam the bit. Copyright 2014—Major Manufacturing PAGE 2...
- Page 4 NOTE: The HIT-66 clamps shown are not part of the HIT-66-266 template set and must be purchased as a separate item. With both clamps opened equally, install both inside and outside templates to the HIT-66 clamp as shown. Do not tighten the 10-32 screws at this time.
- Page 5 4 3/8” holes used to locate the card reader cut out. Drill these holes half way from both sides of the door. Shown are the upper thru bolt holes. PAGE 4 Copyright 2014—Major Manufacturing...
- Page 6 Drill half way from both sides of the door. Drill the 2-1/8” hole for the spindle / lever assembly. Use a hole saw and drill to the mortise pocket from both sides of the door. Copyright 2014—Major Manufacturing PAGE 5...
- Page 7 On a wood door a 3/4” brad point bit may also be used. With all holes drilled, the clamp assembly along with the alignment plate can be removed from the door. Copyright 2014—Major Manufacturing PAGE 6...
- Page 8 2-1/8” hole as shown. See arrow. Draw a second line from the opposite side of the 3/8” hole to the center of the 2-1/8” hole as shown. This notch will be for the wire clearance. PAGE 7 Copyright 2014—Major Manufacturing...
- Page 9 With a jig saw, cut out the rectangle for the card reader. Cut the bottom line first, then the two sides and the top line last. Next, cut out the notch for the wire clearance. DO NOT CUT THROUGH THE DOOR, ONLY THE INSIDE TO THE MORTISE POCKET!
- Page 10 Visit our web site at www.majormfg.com for more information on lock templates and a complete listing of all the tools we have available. While there, sign up for our newsletter and we will email new product information directly to you. PAGE 9 Copyright 2014—Major Manufacturing Inc...