Related Manuals for Major Manufacturing HIT-66-248
Summary of Contents for Major Manufacturing HIT-66-248
- Page 1 1825 VIA BURTON ANAHEIM CA 92806 714-772-5202 / FAX 714-772-2302 EMAIL: MAIL@MAJORMFG.COM WEB: WWW.MAJORMFG.COM INSTRUCTIONS HIT-66-248 TEMPLATE HAGER SERIES MORTISE LOCK WHEN USING POWER TOOLS ALWAYS WEAR EYE AND EAR PROTECTION!!
-
Page 2: Think Safety
Be sure all bits and cutters are sharp and in good condition and all power tools and extension cords are in good working order and properly grounded. AND MOST IMPORTANTLY, BE SURE TO WEAR, EYE AND EAR PROTECTION. Copyright 2012—Major Manufacturing Inc PAGE 1... - Page 3 Shown above is a spade or paddle type the bit to jam. bit. Do not attempt to use this in any drill guide. There is no bearing surface and you will jam the bit. Copyright 2012—Major Manufacturing Inc PAGE 2...
- Page 4 This is used to align the template with the mortise pocket. Shown is a standard mortise pocket, we will use this as a basis for the Hager Mortise Lock installation. Copyright 2012—Major Manufacturing Inc PAGE 3...
- Page 5 With a 3/8” twist drill, drill the thru bolt holes on both sides of the door. These holes go to the mortise cavity. Do not attempt to drill from one side through to the other. PAGE 4 Copyright 2012—Major Manufacturing Inc...
- Page 6 Use a 1-1/4” hole saw to drill the mortise cylinder hole on the outside of the door. Again, back the hole saw out a few times to clear saw dust from the cut. PAGE 5 Copyright 2012—Major Manufacturing Inc...
- Page 7 Visit our web site at www.majormfg.com for more Information on lock templates and a complete listing of all the tools we have available. While there, sign up for our newsletter and we will email new product information directly to you. Copyright 2012—Major Manufacturing Inc PAGE 6...