Config:protect:current:rms:mode; Config:protect:current:peak; Config:protect:current:peak:mode - ITech IT7300 Series Programming Manual

CONFig:PROTect:CURRent:RMS:MODe

This command is used to set current rms protection mode: DELay|IMMediate.
Command syntax
CONFig:PROTect:CURRent:RMS:MODe
Parameters
DELay|IMMediate
Delay: Enable protection after 1s delay.
IMMediate: Turn on protection now.
Example
conf:prot:curr:rms:mod
Query syntax
CONFig:PROTect:CURRent:RMS:MODe?

CONFig:PROTect:CURRent:PEAK

This command is used to configure the current peak protection point. The
command function is equivalent to Ipeak-Protect in the instrument panel menu.
Command syntax
CONFig:PROTect:CURRent:PEAK
Parameters
MINimum|MAXimum|Float
Example
conf:prot:curr:peak 3
Query syntax
CONFig:PROTect:CURRent:PEAK?

CONFig:PROTect:CURRent:PEAK:MODe

This command is used to set current peak protection mode: DELay|IMMediate.
Command syntax
CONFig:PROTect:CURRent:PEAK:MODe
Parameters
DELay|IMMediate
Delay: Enable protection after 1s delay.
IMMediate: Turn on protection now.
del
Copyright © Itech Electronic Co., Ltd.
Configuration Commands
21