Troubleshooting; An Error Message Is Displayed On The Lcd - Canon SELPHY DS810 Photo Printing Manual

Troubleshooting

Let's take a look at countermeasures against problems which may occur during use
of the printer.
Note
Here, we will discuss errors indicated on the LCD, problems that might occur during
direct printing from the digital camera. If you cannot find the symptom corresponding
to a certain problem, refer to the
• "An Error Message is Displayed on the LCD" on page 75
• "Cannot See the Display Properly on the LCD/Cannot See the Display on the LCD" on
page 77
• "Paper Does Not Feed Properly/Paper Jam" on page 77
• "Printing is Blurred/Colors are Wrong/White Streaks appear" on page 78
• "Printed Surface is Scratched or Ink Blots" on page 79
• "Cannot Print Properly from the Digital Camera" on page 81
• "Cannot Install the Printer Driver" on page 83
• "Cannot Print Properly through Wireless Communication" on page 84

An Error Message is Displayed on the LCD

If a message is displayed on the LCD, take the corresponding countermeasure
described below.
Message/Error
There are no photos
in memory card.
Ink tank replaced?
The waste ink
absorber is almost
full.
User's Guide
Try This
• Photo data edited/processed on the computer should be printed
from the computer, not from the camera.
• There is no proper data in the memory card. See "Memory Cards
Supported by this Printer" on page 17.
• If the Ink Tank has been replaced with a new one.
Select Yes to reset the ink counter.
See "Resetting the Ink Counter" on page 73.
• If the Ink Tank has been removed for a certain period (the Ink Tank
has not been replaced)
Select No on the dialog box described above.
The printer has a built-in waste ink absorber to hold the ink used
during Print Head Cleaning, for example.
This error message indicates that the waste ink absorber is nearly full.
Press the OK button to cancel the error so you can continue printing.
However, because printing is disabled once the waste ink absorber
becomes completely full until the waste ink absorber is replaced, you
are recommended to contact a Canon service representative as early as
possible. (You will need to replace a particular part of the printer.)
.
Troubleshooting
75