Assembly Preparation; Assembly Instructions; Mounting The Support Legs To Main Cabinet; Parts Required - Dansons Group PIT BOSS SPORTSMAN PB5000SP Assembly Manual

Wood pellet vertical smoker

Table of Contents

Available languages

Parts are located throughout the shipping carton, including underneath the smoker. Inspect the smoker, parts, and hardware

blister pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the

smoker before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not

attempt to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss Customer Service for parts:

Monday through Sunday, 4am - 8pm PST (EN/FR/ES).

IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.

Tools required for assembly: screwdriver and level. Tools not included.

IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws

completely until all screws for that step have been installed, or unless otherwise mentioned.

1. MOUNTING THE SUPPORT LEGS TO MAIN CABINET

Parts Required:

Main Cabinet (#7)

Front Support Leg - Left (#23)

Back Support Leg - Left (#24)

Front Support Leg - Right (#25)

Back Support Leg - Right (#26)

¼–20x½" Screw ( #B)

12 x

Installation:

•

Place a piece of cardboard on the floor to prevent scratching the unit

and parts during assembly. First, lift the main cabinet door off the

hinges, and place aside. Note illustration 1A

•

Next, flip the main cabinet, bottom side pointed upward, on the

cardboard. Prepare the four support legs for installation, arranging

the labeled legs as shown in illustration 1B.

IMPORTANT: The four support legs must be arranged correctly to be

able to properly install the support panels and support bar in a later

assembly step.

•

Mount one support leg to the smoke cabinet using three screws. Repeat

installation for the other three support legs. Note illustration 1C.