Attaching The Heat Shield; Mounting The Power Cord Bracket; Securing The Grease Tray Brackets - Dansons Group PIT BOSS SPORTSMAN PB5000SP Assembly Manual

6. ATTACHING THE HEAT SHIELD

Parts Required:
1 x Heat Shield (#21)
2 x #10–24x½" Screw ( #D)
Installation:
• Position the heat shield between the control board and the grease
exhaust tube. Secure using a screw on each side.
IMPORTANT: If this part is not installed correctly, the heat and/or splatter
from the grease exhaust tube may cause damage to the control board.
Grease damage to the rear of control board is not covered by warranty.

7. MOUNTING THE POWER CORD BRACKET

Parts Required:
Power Cord Bracket (#12)
1 x
#10–24x½" Screw ( #D)
2 x
Installation:
• Locate the two holes on the bottom of the (left side) support bracket.
Mount the power cord bracket to the support bracket using two
screws as shown in 7A.
• Next, loosen the nut on the pre-mounted clip bracket and guide the
power cord through the clip bracket. Once through, tighten the nut,
and wrap the power cord on the bracket until unit is in use. Note 7B, 7C.

8. SECURING THE GREASE TRAY BRACKETS

Parts Required:
Wire Components Housing (#19)
1 x
Grease Tray Brackets (#17)
2 x
6 x #10–24x½" Screw ( #D)
Installation:
• First, mount the wire components housing onto the base of the auger
housing using two screws in each bracket. Note 8A.
• Secure the grease tray brackets onto the base of the auger housing
and the wire components housing using two screws in each bracket.
Note illustration 8B for proper placement.
NOTE: The diveted end of the brackets should face the control board.
• Fully-tighten all screws on the cart base. Next, carefully turn the unit
into an upright position, with the wheels are on the bottom.
7
6
21
7A 7B
12
7C
8A
8B
17-1
17-2
19