Table of Contents
Advertisement
Available languages
Available languages
13. INSTALLING THE LID STOPPER
Parts Required:
1
x
Lid Stopper (#6)
2
x
#10–24x½" Screw ( #D)
Installation:
•
Install the lid stopper onto the top of the main cabinet near the hopper
lid, using one screw on the top side and one screw on the inside edge
between the hopper lid hinges.
14. MOUNTING THE CABINET DOOR HANDLE, DOOR LATCH
Parts Required:
1
x
Cabinet Door Handle (#10)
Cabinet Door Latch (#11)
1
x
#10–24x½" Screw ( #D)
4
x
Installation:
•
First, remount cabinet door to the main cabinet by aligning and
securing both hinges. Ensure the door is mounted correctly by testing
it opens freely. Note 14A.
•
Mount the cabinet door handle onto the front side of the cabinet door
using two screws. Note correct direction in 14B.
•
Mount the cabinet door latch onto the exterior side of the main
cabinet using two screws. Note 14C.
15. INSTALLING THE COOKING COMPONENTS
Parts Required:
Cooking Grid Support Brackets (#2)
12 x
Cooking Grids (#1)
5
x
1
x
Water Pan (#14)
1
x
Flame Tamer (#15)
Installation:
•
Insert six cooking grid support brackets into the holes along the left
side wall of the interior main cabinet. Once positioned in the holes, tilt
downward to secure into position. Repeat the same process, matching
the same heights, for the right side wall. Note illustration 15A.
•
Place the flame tamer over the burn pot at the bottom of the interior
main cabinet. To ensure proper positioning, align the flame tamer into
the grooves along the bottom of the base panel. Note illustration 15B.
IMPORTANT: The ventilation windows on the sides of the flame
tamer box must not face forward, towards the cabinet door. This
may cause damage to the control board if flames are too large.
•
Next, insert the water pan into the lowest grid support brackets of the
interior cabinet. Fill your water pan about ¾ full of water.
9
13
6
14
14A
10
14B
15A
2
15B
15
15
14C
11
Advertisement
Chapters
Table of Contents
