Dahua XVR User Manual page 196

Parameter Function
Click Device search button, you can view the searched device
Device
search
information on the list. It includes device IP address, port, device
name, manufacturer and type.
Select a device in the list and then click Add button, system can
Add
connect the device automatically and add it to the Added device list.
Or you can double click one item in the list to add a device.
Modify
Click
corresponding channel setup.
Delete
Click
channel.
Connection
status
Delete Select a device in the Added device list and then click Delete button,
system can disconnect the device and remove it from the Added
device list.
Click it, the interface is shown as in Figure 4-20. Here you can add
Manual
Add
network camera manually.
You can select a channel from the dropdown list (Here only shows
disconnection channel.)
Note:
 System supports manufactures such as Panasonic, Sony,
Dynacolor, Samsung, AXIS, Arecont, Dahua and Onvif standard
protocol.
 If you do not input IP address here. System uses default IP
192.168.0.0 and system does not connect to this IP.
 Can not add two devices at the same time. Click OK button here,
system only connect to the corresponding device of current
channel.
4.8.1.2 Conditions
Here you can view device property information. The setups become valid immediately
after you set.
The analog channel is shown as in Figure 4-21.
or any device in the Added device list, you can change the
, you can delete the remote connection of the corresponding
: Connection succeeded.
: Connection failed.
187