Haussmann MT250 Manual page 24

INSTRUCTIONS FOR USE
Mounting/Replacing the Application Tool/
Accessory
Mount the application tool/accessory (e.g.
plunge cut saw blade in such a way on the
tool holder that the openings of the tool
engage into the cams of the tool holder.
For a safe and fatigue-free working position it is
possible to position the application tools/
accessories in any snap-in positions on the tool
holder. Position the tool in such a way that the
depressed centre points downwards (marking
on the graphics page).
Use the screw to fasten the application tool/
accessory.
Tightly fasten the scr ew with the allen key.
Check the tight seating of the application tool/
accessory. Incorrect or not securely fastened
application tools/accessories can come loose
during operation and pose a hazard.
For removing the application tool/accessory
loosen the screw with the allen key and
remove the tool.
Selecting the Sanding Sheet
sanding sheets are available:
Particle size
Coarse
40
Medium
80, 100, 120
EN
Fine
180 to 400
24
Material
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
Mounting/Replacing a Sanding Sheet on the
Sanding Plate
for quick and easy fastening of sanding sheets
with Velcro adhesion.
Before attaching the sanding sheet, free the
Velcro backing of the sanding plate from any
debris by tapping against it in order to enable
optimum adhesion. Position the sanding sheet
then lay the sanding sheet onto the sanding
plate and press it against it with a light turning
motion in clockwise direction.
To ensure optimum dust extraction, pay
attention that the punched holes in the sanding
sheet match with the holes in the sanding plate.
To remove the sanding sheet, grasp it at one
polishing cloth pads of the HAUSSMANN series
available at your nearest RONA store.
polishing cloth pads, are attached to the sanding
plate in the same manner.
Application
Coarse grinding/sanding (initial
grinding/sanding)
Remove old coatings, etc.
Fine grinding/sanding
Removal of slight unevenness,
paint spots, etc.
painting
Polishing
,