Operation And Instructions For Use - Haussmann MT250 Manual

OPERATION AND INSTRUCTIONS FOR USE

Assembly
Changing the Tool
Before changing accessories or doing any other
operation on the tool, ensure tool is unplugged
from the power source.
Selecting the Application Tool/Accessory
A c e c s s o y r
Segment saw
blade
Plunge cut saw
blade, wood (large)
Base plate for sand-
ing, series Delta
Plunge cut saw
blades, wood(small)
Rigid scraper blade
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching the
saw blade.
M a e t i r l a A
Wooden materials, Separating and plunge cuts; also for sawing
plastic, close to edges, in corners and hard to reach
non-ferrous metals areas;
Example: shortening already installed bottom
rails or door hinges, plunge cuts for adjusting
Wooden materials, Separating and deep plunge cuts; also for
plastic, gypsum and sawing close to edges, in corners and hard to
other soft materials reach areas;
Example: Sawing
ings
Depends on sanding Sanding surfaces close to edges, in corners or
sheet hard to reach areas;
Depending on the sanding sheet for, e.g.,
sanding wood, paint, varnish, stone, glass
Wooden materials, Smaller separating and plunge cuts;
plastic, gypsum and Example: Cut-outs in furniture for cable con-
other soft materials nections
Carpets, coverings
p p c i l t a o i n
panels
water pipes (PVC) or
For removing tough old lacquers,
remainders of adhesives, carpeting, tile
adhesives and under seal coatings.
EN
23