Description And Specifications Instructions - Haussmann MT250 Manual

DESCRIPTION AND SPECIFICATIONS INSTRUCTIONS

Description of symbols
The rating plate on your tool may show symbols.
These represent important information about
the product or instructions on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Tool is listed by INTERTEK and listed
c
to Canadian Standards by INTERTEK
Environmental protection
Recycle unwanted materials instead
of disposing of them as waste. All
tools, hoses and packaging should be
sorted, taken to the local recycling centre and
disposed of in an environmentally safe way.
Voltage
Input power
No-load speed
Safety instructions
General safety instructions
WARNING. When using electric tools basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
personal injury including the following. Read all
these instructions before attempting to operate
this product and save these instructions.
Save these instructions.
WORK AREA
1. Keep your work area clean and well
lit. Cluttered benches and dark areas invite
accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases, or dust. Power
tools create sparks which may ignite the dust or
fumes.
3. Keep bystanders, children, and visitors
away while operating a power tool.
Distractions can cause you to lose control.
Protect others in the work area from debris such
as chips and sparks. Provide barriers or shields
as needed.
ELECTRICAL SAFETY
4. Double Insulated tools are equipped with
a polarized plug (one blade is wider than the
other.) This power plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to
install a polarized outlet. Do not change the
plug in any way. Double Insulation
eliminates the need for the three wire grounded
power cord and grounded power supply system.
5. Avoid body contact with grounded
surfaces such as pipes, radiators, ranges
and refrigerators. There is an increased risk of
electric shock if your body is grounded.
120 V ~ 60 Hz
2.2 Amp
6. Don't expose power tools to rain or wet
conditions. Water entering a power tool will
15000~22500 RPM
increase the risk of electric shock.
7.
cord to carry the tools or pull the plug from an
outlet. Keep cord away from heat, oil, sharp
edges or moving parts. Replace damaged
cords immediately. Damaged cords increase
the risk of electric shock.
8. When operating a power tool outside, use
outdoor extensions cord marked"W-A" or
"W" . These cords are rated for outdoor use and
reduce the risk of electric shock.
PERSONAL SAFETY
9. Stay alert, watch what you are doing, and
use common sense when operating a power
tool. Do not use tool while tired or under the
influence of drugs, alcohol, or medication.A
moment of inattention while operating power
tools may result in serious personal injury.
10. Dress properly. Do not wear loose clothing
or jewelry. Contain long hair. Keep your hair,
clothing, and gloves away from moving parts.
Handle the cord carefully. Never use the
EN
19