Sliding Window Installation; Assembling The Sliding Window Adapter - Toshiba RAC-PT1411HWRU User Manual

Foam seal B
(Adhesive
type-shorter)
Foam seal A
(Adhesive
type)
(Front + Rear)
Air
Divider
Foam seal C
(Non-adhesive type)
Page 16
Type 2: Sliding window Installation (Optional)
1. Cut the adhesive foam seal A and B strips to the proper
lengths, and attach them to the window sash and frame as
shown.
2. Assembling the Sliding Window Adapter (Only needed
for Sliding Window applications): Align both halves of the
sliding window adapter and connect them. Then, attach
the air divider to the newly formed window adapter on the
outdoor side. The fully assembled adapter should look like
the image at the left.
Sliding
3. Insert the window slider assembly into the window track. If the
Window
hose opening is covered by the window frame, rotate the panel
Adapter
so the thicker side faces the window frame. Attach the Window Kit
Brace to the back of the hose panel to brace against the window
so the window slider panels do not lean inward.
4. Be sure bolts are installed in both sides of the window slider for
improved rigidity.
5. Cut the non-adhesive foam seal C strip to match the
window height. Insert the foam seal between the glass and
the window frame to prevent air and insects from getting
into the room.
Window slider B
(if required)
Window slider A
Window
Kit Brace
User Manual