Advertisement
Quad Phase HP
Universal DMX Control: This function allows you to use a Elation® universal DMX-512
controller to control the patterns, rotation and strobing. A DMX controller allows you to
create unique programs tai- lored to your individual needs.
1. The Quad Phase HP is a four DMX channel DMX fixture. See page 14 for detailed
description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures on pages 5-7 as
well as the set-up specifications that are included with your DMX controller.
3.
U se the controller's faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instructions on page 8 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
7.
F or help operating in DMX mode consult the manual included with your DMX controller.
Sound Active Mode: This mode allows a single unit or several units linked together, to
run to the beat of the music.
1. Tap the MENU button until "SOUN" is displayed, and press ENTER.
2. Press the UP or DOWN button so that "ON" is displayed. The unit will now run to the
beat of the music.
3. The sound sensitivity can be adjusted by pressing the MENU button until "SENS" is
displayed, and then press ENTER. Use the UP or DOWN buttons to adjust the sound
sensitivity, 1 being the least sensitive, and 100 being the most sensitive.
4. The optional UC3 Controller (not included) may be used to control different functions
including blackout.
Primary-Secondary Operation (Sound Active): This function will
a llow you to link up to
16 units together and operate without a controller. The units will be sound activated. In
Primary-Secondary operation one unit will act as the controlling unit and the others will
react to the controlling units programs. Any unit can act as a Primary or as a Secondary.
1. Using standard XLR microphone cables, daisy chain your units together via the XLR
connector on the rear of the units. Remem- ber the Male XLR connector is the input
and the Female XLR connector is the output. The first unit in the chain (Primary) will
use the female XLR connector only - The last unit in the chain will
u se the male XLR
connector only. For longer cable runs we suggest a
2. On the Primary unit find your desired show and set that show by pressiing the ENTER
button.
3. On the secondary units tap the MENU button until "SCND" is displayed, select your
desired secondary mode and Press ENTER.
4.
T he Secondary units will now follow the Primary unit.
5. The optional UC3 Controller (not included) may be used to con- trol different functions
including blackout.
ADJ Products, LLC - www.adj.com - Quad Phase HP - User Manual - Page 12
Operation
terminator at the last fixture.
Advertisement
