Using The Memory Card Startup Utility - Canon BJC-S820D Quick Start Manual

Printing Without a Computer

Using the Memory Card Startup Utility

You'll need your computer to use the Memory Card Startup Utility. Use this utility
to change the settings when you insert a memory card or to change the read/write
mode of the card slot.
Normally, the Memory Card Startup Utility starts automatically when you insert a
memory card. To start it manually, follow the instructions below.
42
If you eject a memory card while the access lamp is on or
blinking, the memory card may not operate properly.
Always use the Memory Card Startup Utility to eject a
memory card.
Before you eject a memory card, be sure to discard the
icon into the Trash.
When you select Change the drive's read/write attribute and set
the Read/Write-Enabled Mode, note the following points:
•
Change the write protection (switch or seal to prevent
accidental erasing) of the memory card to write-enabled
mode before inserting the memory card. If you insert a write-
protected card, the computer may not operate normally.
•
If you change the contents of a memory card, you must format
the memory card with a digital camera, otherwise you may
not be able to take photographs. This printer supports only
the format used by the digital camera.
•
If you change or manipulate the contents of a memory card
from a computer, be sure to print the contents from the
computer. If you print the contents from the Operation Panel,
the information may not print properly.