Error Codes - Brother BAS-311F-0 Instruction Manual

12. ERROR CODES

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
If an operation problem occurs, a buzzer will sound and an error code will appear on the display screen;
if a programmer is connected, an error message will appear on the screen.
Code
E.10 Emergency stop switch was pressed.
E.11 Emergency stop switch was pressed.
E.12 Emergency stop switch is activated or its
connection is not correct.
E.13 Defective connection of model selection connector.
E.14 Foot switch was depressed, or connection of foot
switch is defective.
E.15 Start switch was depressed, or connection of start
switch is defective.
E.16 Machine head was tilted back.
E.17 Operation panel switch was depressed when power
was turned on.
E.20 Motor malfunctions
connected correctly.
E.21 Motor malfunctioned.
E.22 Needle up stop position error.
E.30 Data exceeds available sewing area due to resize
ratio.
E.31 Stitch length exceeds 12.7mm due to resize ratio.
E.32 No end code in sewing data.
DANGER
Cause
or synchronizer is
BAS-311F-0, 311F-L, 326F-0
Turn the EMERGENCY STOP switch clockwise and
then pull it forward to release it. Press the STEP BACK
(RESET) switch on the operation panel.
Turn the EMERGENCY STOP switch clockwise and
then pull it forward to release it. Press the STEP BACK
(RESET) switch on the operation panel.
You can start sewing again, press the STEP BACK
switch once more.
Turn off power and check it.
Turn off power and check connector P26.
Turn off power and check it.
Turn off power and check it.
Turn off power and tilt machine head back.
Turn off power and check it.
not Turn off power and check machine, synchronizer
connection, and connectors P12 P15 P16.
Turn off power and check ground wire connection.
Turn pulley to align timing mark with that on belt cover.
Adjust resize ratio.
Adjust resize ratio.
Input end code, or change program No.
12. ERROR CODES
Remedy
63