Installing The Control Box - Brother BAS-311F-0 Instruction Manual

3-3. Installing the control box

(8)
(9)
(10)
(2)
1291S
1. Remove the screws (1), and then open the covers (panel mounting assembly (2) and main P.C. board mounting plate
(3)).
Caution: When opening the cover, hold it securely so that it does not fall down.
2. Install the control box with the four accessory bolts (4), spacers (5), flat washers (6) and nuts (7) as shown in the
illustration above.
* At this time, leave a gap of approximately 1 mm between the work table and the top of the box.
3. Close the covers (panel mounting assembly (2) and main P.C. board mounting plate (3)), and tighten them with the
screws (1).
* The main P.C. board mounting plate (3) will be opened again during "3-11. Connecting the cords", so provisionally
tighten it with the screw (1).
4. Install the power switch (8) with the two screws (9).
5. Secure the power switch cord with the five staples (10).
Note
Secure the motor cord with staples in such a way that it does not cross over the outlet port of the cooling fan (11)
Some specifications are not supplied with an accessory power switch (10). For these specifications, connect a
power switch which satisfies the necessary regulations in the country of use.
0064Q
(4)
(5)
(6)
(7)
(1)
(3)
Red
White
Black
Yellow/
BAS-311F-0, 311F-L, 326F-0
(5) Spacer
(6) Flat washer
(7) Nut
Connect to the power switch. However,
the black wire is insulated to the inside of the
box and is not used.
Connect to ground
3. INSTALLATION
(11)
1292S
5