Adjusting The Presser Foot - Brother BAS-311F-0 Instruction Manual

9. STANDARD ADJUSTMENTS
(5)
(8)
(6)
(2)
Pin
(5)

9-7. Adjusting the presser foot

Turn the pulley by hand to lower the presser foot to the down position, and then proceed with the steps below.
(4)
(3)
46
(4)
(3)
(7)
(1)
(1)
(2)
BAS-311F-0, 311F-L, 326F-0
4. Fit the thread cutter connecting rod (6) on connecting
lever pin (7), and install needle plate (5).
When fitting the connecting rod (6) on the
connecting lever pin (7) and before tightening
screws (3) and (4), move the needle plate back
and forth a little bit to confirm that the movable
knife (8) is pulled by the connecting rod (6).
1249S
5. When installing the feed plate (2), use a 2 mm-
diameter pin (such as a needle) to align the hole in the
needle plate (5) with the hole in the feed plate (2)
BAS-311F-0, -L
home position", BAS-326F-0
machine has moved 20 mm (400 pulses) backward (in
the Y direction) from the home position" and then
tighten the screws (1).
1250S
1. Loosen screw (1), set the bottom of the presser foot
(2) lightly against the work piece, and then tighten
screw (1).
Note
If the presser foot is lowered too far, the work piece
will shift when sewing. Also, if the presser foot is too
high, skipped stitches may occur.
2. Turn the pulley by hand, and make sure the needle
enters the center of the needle hole in the presser foot
(2). If the needle is not aligned with the center of the
needle hole, remove cap (3), loosen screw (4), and
turn the presser foot (presser bar) to adjust.
If the needle projects past the presser foot when
the presser foot is raised, injury may result.
1251S
"when the machine is at the
"when the sewing