Tilting The Sewing Machine Head - Brother BAS-311F-0 Instruction Manual

3-9. Tilting the sewing machine head

BAS-311F-L, 326F-0 : Remove the X feed base cover (1) and the feed base cover support (3) (below) from the machine
head before tapping the head rest (5) (next page) into the work table.
BAS-311F-L
(1)
1166S
1. Loosen the screws (2) which are holding the X feed base cover L assembly (1) by about 2-3 turns, and then remove
the X feed base cover L assembly (1) in the direction of the arrow in the illustration.
Note
The sewing machine is packed without the X feed base cover L assembly (1) installed.
(3)
1168S
2. Loosen the screws (4) which are holding the feed base cover support (3) on the left of the sewing machine (when
looking from the front of the sewing machine) by about 2-3 turns, lift the feed base cover support (3) up slightly (BAS-
311F-L) or down slightly (BAS-326F-0), and then remove it in the direction of the arrow in the illustration.
Note
The sewing machine is packed without the feed base cover support (3) installed.
(2)
BAS-311F-L
(4)
BAS-311F-0, 311F-L, 326F-0
BAS-326F-0
(1)
BAS-326F-0
(3)
3. INSTALLATION
(2)
1167S
(4)
1169S
9