Confirming Settings Of Your Access Point - Canon PIXMA MP800R Setup Manual

Confirming Settings of your Access Point

When setting up the machine to be used over wireless LAN, the machine's network settings are
configured to match those of the access point. Therefore, if you are using wireless LAN, we
recommend that you confirm the necessary information on the access point before entering the
setup process. Check and fill in the table below.
SSID/network name
Stealth/closed network
*2
ANY-Rejection
Radio channel
Encryption
MAC address filtering
IP address filtering
Client-to-Client Blocking
*1
In the stealth mode, an access point hides itself by not broadcasting its SSID. The client must
specify the SSID set to the access point to detect it. In Macintosh, the stealth mode is called a
"closed network".
*2
Any rejection is a feature of an access point to hide itself from and/or reject connection with clients
whose SSID/network name is set to "ANY".
*3
This machine supports the methods below. If you are using another method, change the WPA/
WPA2 settings on the access point and computers to match these.
Authentication method: WPA-PSK (WPA Personal) or WPA2-PSK (WPA2 Personal)
Encryption method: TKIP or AES
*4
If Client-to-Client Blocking is enabled, clients are not allowed to communicate with other clients
associated with the same access point.
Note
For information on how to confirm the settings of the access point, refer to the manual provided with the
access point or contact its manufacturer.
If Stealth (closed network) or ANY-Rejection feature is enabled
We recommend you to disable it before entering setup.
If MAC address filtering is enabled
You must register the machine's MAC address to the access point before entering setup. To
confirm the MAC address of the machine, print the machine's network information. See
Out Network Setting Information" on page
*1
Disabled
Disabled
Automatic
Channel (
: The machine can communicate in channels 1 to 11.
Disabled
Disabled
Disabled
*4
Disabled
72.
Enabled
Enabled
)
WEP Enabled
key (
WPA or WPA2 Enabled
key (
Encryption (TKIP · AES)
Enabled
Enabled
Enabled
Confirming the Setup Environment
)
*3
)
"Printing
21