Canon PIXMA MP800R Setup Manual page 45

9
When the screen shown on the right appears,
remove the USB cable and click [Next].
The network connection between the machine and
the computer is now successfully established.
10
Place the machine in the location where you will use it, then turn it on.
11
Click [Next] in the [Connection Performance
Measurement] dialog box.
Measuring of the communication performance
starts, and the results are displayed.
Note
Measuring takes a few minutes. You can cancel
measuring by clicking [Cancel].
You can also execute the same measurements by
using the Canon IJ Network Tool.
12
Confirm the measurement results, then click
[Finish].
Ensure that
performance between the printer and the access
point].
Note
If any symbol other than
displayed comments and Help for improving the
status of the communication link.
To check whether the new location is better, click
[Remeasurement] after moving the machine.
Measurement of the communication status is
performed again.
When any message on [Overall network
performance] appears in the measurement results,
rearrange the machine and other network devices
following the instructions on the screen.
The Printer Setup Utility (Printer Center on Mac OS X v.10.2) and Canon IJ Network Scanner
Selector will start up.
44 Setting Up the Machine and the Computer (Macintosh)
is displayed in [Connection
is displayed, refer to