Connect The Power Cord - Canon MultiPASS F20 Setup

Remove the shipping material from the machine.
1
Place the machine on a flat surface.
2
Remove all shipping tapes from the exterior of the machine.
NOTE
• DO NOT remove the USB label A at this stage.
USB label A

Connect the power cord.

NOTE
• Before turning on the power, make sure the document cover A is closed.
1
Plug the power cord
into a socket.
Attach the multi-purpose tray and load paper.
1
Insert the tabs on the bottom edge of the multi-purpose tray into the holes on
the machine as shown.
2
When you connect the
machine, the Alarm light blinks,
and the messages below
should appear in the LCD.
A
P L E A S E W A I T
Approx. 30 seconds
P U T I N C A R T R I D G E
NOTE
• Please note that the cartridge
(printhead and ink tanks) is
installed in steps 5 and 6.
3
If nothing appears
in the LCD, press
[ON/OFF] to turn
on the machine.
Co