Connect The Power Cord; Load Paper - Canon imageCLASS MP730 Setup Sheet

Connect the power cord.

IMPORTANT
• Before turning on the power, make sure the document cover A is closed.
1
Plug the power
cord into a socket.

Load paper.

Place a stack of paper (print-side up) in the multi-purpose tray
guide A and adjust to the width of the stack w. Then place the tray cover D over
the multi-purpose tray e.
A
B
NOTE
• Make sure the stack does not exceed the paper limit mark B or tab C. Otherwise a paper
jam may occur.
A
P L E A S E W A I T
Approx. 30 seconds
D I S P L A Y L A N G U A G E
< E N G L I S H
2
When you connect the
machine, the above messages
should appear in the LCD.
• If nothing appears in the LCD,
press [ON/OFF (1 sec.)] to turn on
the machine.
w
q
C
>
3
Use [2] or [3] to select
the language for the
LCD, then press [OK].
q. Pinch the paper
Turn over to
Turn over to
continue
continue
e
D