Installing A Din Rail - Cisco Catalyst IR1800 Series Installation Manual

Installing the Router
Step 2 Use four #10 screws when mounting the unit to the neighboring surface. The screws must be long enough to
penetrate at least 1.0 inch (25.4 mm) into the supporting wood or metal wall stud. See the following figure for
guidance.
Figure 7: Mounting Holes
Step 3 Route the cables so that they do not put a strain on the connectors or mounting hardware.
Note

Installing a DIN Rail

The DIN rail kit must be ordered separately. The Cisco part number is IR1800-DINRAIL.
Note The DIN rail brackets come assembled in horizontal orientation. If your installation requires vertical orientation,
disassemble the components and reassemble them.
If you are mounting the device into a hollow wall, ensure that the wall material can support the
router's weight. Use appropriate wall anchor mounts.
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide

Installing a DIN Rail

29