Before Getting Started; Place The Drill Holes; Attaching The Exhaust Hood - privileg SY-103E6S-E11-C29-L12-900 User Manual

Before getting started

• Read chapter "Safety" on page EN-4 and
all the safety notices.

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■ Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■ The distance between the cooking
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas stoves.
■ For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall. Ideally, use a level or a plumb
bob from the ceiling of the room to the
middle of the stovetop.
2. Draw the six drill holes on the wall, following
the diagram on page 12. Make sure the dis-
tances between the holes are correct.
3. Drill holes at the marked points, using a di-
ameter that can accommodate the dowels.
4. Place the dowels into the holes.
Assembly

Attaching the exhaust hood

(5)
Stifte
1. Place the two halves of the check valve (5)
into the opening on the top of the exhaust
hood (1). Make sure that the pins on the
valve are facing outwards.
2. Screw the two round-head screws (11) for
hanging the exhaust hood into the dowels.
There must be enough space between the
wall and the heads of the screws so that
the exhaust hood can be hung by the key-
hole openings.
(13)
3. Flip the cover (13) up.
4. Open the locks (14) on the grease fil-
ters (15) and carefully pull the grease fil-
ters (15) downwards to remove them.
Page EN-13
(5)
(14)
(15)