Trouble Shooting - Parkside PHSL 900 A1 Translation Of The Original Instructions

IE
GB NI

Trouble Shooting

Problem
Device does not start
Device runs with inter-
ruptions
Blades become hot
18
CY
Possible cause
Mains voltage not on
On/Off switch (
A
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (
A
defective
Blades ( 1) are blunt
A
Blades ( 1) are notched
A
Too much friction due to lack
of lubrication
Fault correction
Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
16)
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
16)
Have the blades (
or replaced (Service Centre)
Have the blades (
or replaced (Service Centre)
Oil the blades (
1) sharpened
A
1) checked
A
1)
A