Canon EOS 10D Software Instructions page 91

● Is the driver operating normally?
Connect the camera to your computer
with the interface cable and set the
camera's main switch to <ON> (➞W-10)
and open the [Device Manager] (➞W-80).
Click the plus symbol [+] to the left of
[Imaging devices] and check that [EOS
10D] is displayed.
➞ If [EOS 10D] does not appear, the driver is not operating normally. Briefly disconnect and
then reconnect the interface cable, ensuring that the connection is secure. If [EOS 10D]
still does not appear, use the following procedure to re-install the driver.
1
Disconnect the interface cable and uninstall the driver. (➞W-82)
2
Re-install the driver. (➞W-4)
➞ When the [X], [!] or [?] symbol is displayed beside [EOS 10D], part of the driver is
missing or corrupted. Use the following procedure to re-install the driver.
1
Delete [EOS 10D] displayed in [Imaging devices].
2
Disconnect the interface cable and uninstall the driver. (➞W-82)
3
Re-install the driver. (➞W-4)
Troubleshooting
W
7
W-79