Canon EOS 10D Software Instructions page 19

13
Set the camera's main switch to <ON>.
\
Driver installation ends.
●
The completion of driver installation is only performed the first time you connect the
camera to your computer after installing the drivers from the SOLUTION DISK.
●
Once installation is completed, an event dialog box or the [Scanner and Camera
Wizard] dialog box appears. Click the [Cancel] button to close the displayed dialog
box.
●
When the message appears prompting you to restart your computer, restart your
computer as directed by the message.
●
When driver installation ends, set the camera's main switch to <OFF>.
Depending on your operating system and computer system, the [Creating driver
information database] or [Found new hardware] dialog box may appear when you set
the camera's main switch to <ON>.
When You Have Problems with Driver Installation
If you have problems with driver installation, check the items listed below. If the [Add New
Hardware Wizard] ([Found New Hardware Wizard] in Windows 2000) dialog box appears while
you are checking these items, click the [Cancel] button and disconnect the camera from your
computer. Then re-install the driver software.
(1) Does your computer comply with these requirements?
●
PC with Windows XP, Windows 2000, Windows Me or Windows 98 SE preinstalled and
a USB port as a standard feature. (➞ A-9)
(2) Is the camera connected correctly?
●
See steps 11 and 12 (➞W-6) for the connection method.
(3) Are the camera and computer set up correctly for communication?
●
Is the camera's main switch set to <ON>?
●
Even when the camera's main switch is set to <ON>, operation of the Auto power off
function will automatically switch the camera off. To prevent this, set the Auto power off
to [Off]. (Refer to "Menu Settings" in the EOS 10D Instructions.)
(4) Is there sufficient charge left in the camera battery?
●
When you connect your camera to a computer, you should use the DC Coupler Kit
(optional) so that you can continue to use your camera regardless of battery level.
If you have checked that none of the above problems apply and you still have problems with
the driver installation, follow "Uninstalling the Driver" (➞W-82) and perform the driver
installation procedure once more from the beginning.
Installing the Software
W-7
W
1