Brother P-touch 2600, 2610 User Manual page 116

Error Message
CAN'T This message appears if the cursor is
HERE! at the end of the text when you hold
down c and press O.
CASSETTE This message appears if the tape cas-
CHANGED! sette is changed while the P-touch is
receiving data from the computer.
CHANGE This message appears if a high-volt-
ADAPTOR! age adapter is being used.
CUTTER This message appears if the tape cut-
ERROR! ter is closed when you try to print or
feed the tape.
EEPROM This message appears if a checksum
ERROR! error occurred when the P-touch was
turned on or if the keyword was dam-
aged and failed to initialize.
FEED This message appears if the AV label
ERROR! sensor cannot detect the labels.
INPUT This message appears if the set
WHOLE CODE number of digits is not entered in the
barcode data.
Cause Remedy
Move the cursor below a
number before holding down
c and pressing O.
Cancel the print job, install the
correct tape cassette, and then
try printing again.
Remove the high-voltage
adapter and connect the adapter
designed exclusively for this
machine.
Turn the P-touch off, then on
again.
Contact your service representa-
tive.
• Replace the AV label cassette
with one that is not empty.
• If this error message appears
even after a new AV label cas-
sette is installed, the sensor
may be damaged. Contact
your service representative.
Input the correct number of dig-
its or change the number of dig-
its set in the barcode parameters.
109