Using Timer; Off Timer Operation/On Timer Operation - Mitsubishi Electric MJ-E100AR-H Instruction Manual

Using Timer

OFF TIMER operation
The OFF TIMER can be set between 1 to 9 hours. Set
the timer when the power is switched on.
Setting OFF TIMER
1
Switch the power ON.
z Select operation mode.
z Select the louvre swing direction.
2
Set the operation
time.
z Press once to display " " "
z Each press will change the display in
the sequence of 1 to 9 hours.
(Holding the switch will cause the display to
change continuously.)
.. . .. .
Blip
→
The OFF TIMER is set.
z The remaining time will decrease one
hour after each hour elapses.
z When the set time is reached, the unit stops
automatically and the louvre closes automatically.
DRYING INSIDE (auto) operation will start if it
has been activated. P18
Cancellation
<When you want to stop operation>
Press POWER switch g OFF
<When you want to disable the OFF
TIMER mode and continue operation>
Press and hold the ON/OFF TIMER switch until
the remaining time disappears from the display.
z Empty the water tank before operating. During operation, if the
tank becomes full, the FULL lamp lights and the unit stops.
z The OFF TIMER and ON TIMER cannot be set at the same time.
z If the OFF TIMER mode is used with the INTELLIGENT
LAUNDRY, NIGHT LAUNDRY or MILDEW GUARD, the unit may
stop before the laundry or the bathroom is dry.
z The OFF TIMER cannot be set during DRYING INSIDE operation.
2 1
P10–14
P16
Blip
Press
" .
Blip Blip
Blip
No display
ON TIMER operation
The ON TIMER can be set between 1 to 9 hours.
Set the timer when the POWER is off.
Setting ON TIMER
1
Switch the power OFF.
2
Set the time you
wish the unit to
turn ON.
z Press once, the operation mode
indicator and " " on the digital display
flash, and "
z Each press will change the display in
the sequence of 1 to 9 hours.
(Holding the switch will cause the display to
change continuously)
......
Blip
z Select operation mode.
Set the DRYING INSIDE (auto) operation as
desired. P18
z Select the louvre swing direction.
3
Confirm the time
setting by pressing
the POWER switch.
z The timer display lights.
g The ON TIMER is set.
If both the timer display and operation mode indicator
blink, it means the POWER switch is not pressed.
(An alarm "blip blip" sounds for 1 minute.)
z The remaining time will decrease one
hour after each hour elapses.
z When the set time is reached, the
unit automatically starts.
Cancellation
Press POWER switch g OFF
z When the ON TIMER is set during the DRYING
INSIDE operation, the operation is stopped.
z The ON TIMER function is not operable using a
commercially-available timer plug.
2 1 . 3
Blip
Press
" is displayed.
Blip Blip
Blip
No display
P10–14
Blip
Press
P16
17