Advertisement
March 2020
2
Install
2.1
Unpack and inspect
WARNING
Buffer solution in the vinyl boot may cause skin or eye irritation.
CAUTION
Wet electrode tip at all times to maximize storage life.
CAUTION
Cable connection at back of sensor body is fragile.
Do not overtighten.
Procedure
1. Inspect the outside of the carton for any damage. If you detect
damage, contact the carrier immediately.
2. Inspect the hardware. Make sure all the items on the packing list are
present and in good condition. Notify the factory if any part is
missing.
Postrequisites
If the sensor appears to be in satisfactory condition, proceed to .
Note
Save the original packing cartons and materials as most carriers require
proof of damage due to mishandling, etc. Also, if you need to return the
sensor to the factory, you must pack it in the same manner as it was
received. Refer to for return instructions. If storing the sensor, fill the vinyl
boot with pH buffer solution and replace it on the sensor tip until you are
ready to use it.
Quick Start Guide
Quick Start Guide
7
Advertisement
