Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document require the following tools:
● Phillips #0 screwdriver
● Phillips #1 screwdriver
● Flat headed screwdriver
● Plastic scribe
Screw List
The following table shows the screw list and the image of the screws.
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Side cover
System board
Hard drive support
Fan and heat sink assembly
WLAN card
Screw type
Quantity
#6-32
1
#6-32
4
M2x4
3
1
#6-32
M3x25
3
M2x3.5
1
Removing and installing components
2
Image
9