Dell OptiPlex 7090 Micro Form Factor Service Manual page 52

Table 9. System setup options—Power menu (continued)
Power
Active State Power Management
Aspm
Block Sleep
Deep Sleep Control
Fan Control Override
Intel Speed Shift Technology
Table 10. System setup options—Security menu
Security
TPM 2.0 Security
TPM 2.0 Security On
Attestation Enable
Key Storage Enable
SHA-256
Clear
PPI ByPass for Clear Commands
Chassis intrusion
SMM Security Mitigation
Data Wipe on Next Boot
Start Data Wipe
Absolute
52 System setup
Enables or disables the Active State Power Management (ASPM) level
By default, the Auto option is enabled.
Enables to block entering sleep (S3) mode in the operating system.
By default, the Block Sleep option is disabled.
Enable or disable the Deep Sleep mode support.
By default, the Disabled option is enabled.
Enable or disable the fan control override feature.
By default, the option is disabled.
Enable or disable the Intel speed shift technology support.
By default, the Intel Speed Shift Technology option is enabled.
Enable or disable TPM 2.0 security options.
By default, the TPM 2.0 Security On option is enabled.
Enables to control whether the Trusted Platform Module (TPM) Endorsement
Hierarchy is available to the operating system.
By default, the Attestation Enable option is enabled.
Enables to control whether the Trusted Platform Module (TPM) Storage
Hierarchy is available to the operating system.
By default, the Key Storage Enable option is enabled.
BIOS and the TPM will use the SHA-256 hash algorithm to extend
measurements into the TPM PCRs during BIOS boot.
By default, the SHA-256 option is enabled.
Enables to clear the TPM owner information and returns the TPM to the
default state.
By default, the Clear option is disabled.
Controls the TPM Physical Presence Interface (PPI).
By default, the PPI ByPass for clear Commands option is disabled.
Controls the chassis intrusion feature.
By default, the option is disabled.
Enable or disable SMM Security Mitigation.
By default, the option is enabled.
Enable or disable the data wipe on next boot.
By default, the option is disabled.
Enable or disable or permanently disable the BIOS module interface of the
optional Absolute Persistence Module service from Absolute software.