Graphics Card; Removing The Graphics Card - Dell OptiPlex 7090 Micro Form Factor Service Manual

Steps
1. Align and lower the system board into the system until the connectors at the back of the system board align with the slots
on the chassis, and the screw holes on the system board align with the standoffs on the system.
2. Replace the three (M3x4) screws and three (6-32) screws to secure the system board to the chassis.
3. Align the slot on the hard drive support with system board and place the hard drive support on the system board.
4. Replace the screw (6-32) to secure the hard drive support to the system board.
Next steps
1. Install the processor.
2. Install the speaker.
3. Install the memory module.
4. Install the fan assembly.
5. Install the WLAN card.
6. Install the solid-state
7. Install the graphics card.
8. Install the side cover.
9. Follow the procedure in

Graphics card

Removing the graphics card

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
drive.
after working inside your
before working inside your
computer.
computer.
Removing and installing components 41