Black+Decker MTHD5 Manual page 4

ENGLISH
Use clamps or another practical way to se-
u
cure and support the workpiece to a stable
platform. Holding the work by hand or against
your body leaves it unstable and may lead to
loss of control.
Before drilling into walls, floors or ceilings,
u
check for the location of wiring and pipes.
Avoid touching the tip of a drill bit just after
u
drilling, as it may be hot.
This tool is not intended for use by persons
u
(including children) with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for
their safety. Children should be supervised to
ensure that they do not play with the appliance.
The intended use is described in this instruc-
u
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
4
(Original instructions)
Features (fig. A)
Tool shown is MT143. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
8. Torque adjustment collar
10. Speed selector
Assembly
Warning! Before assembly, remove the battery
from the tool.
Use
Warning! Let the tool work at its own pace. Do not
overload.
Drilling in masonry (fig. D & E)
For drilling in masonry, set the torque adjust-
u
ment collar (8) to the hammer drilling position
by aligning the symbol with the marking.
Slide the speed selector (10) towards the front
u
of the tool (2nd gear).
Note: For other torque adjustment collar settings
and features, refer to the manual provided with
your power tool.