Table of Contents
Advertisement
1.3
Deploying the RX50 Hardware
If the RXV100-B40 bundle is purchased, the RX50 is included. Developed in partnership with
Dolby®, the device serves as a peripheral speaker producing clear, natural-sounding voice quality
regardless of acoustic room design (wall contour and surface material). Full-room pickup and
dynamic leveling automatically increase the volume of quiet or distant voices, while unwanted noise
is filtered, ensuring every participant's voice is heard regardless of room shape, size, or orientation
within the room. Optional satellite microphone kit extending pickup reach by 2 meters/6.5 feet.
To connect:
1.
Connect the RX50 to the network.
2.
After connecting to the network, the RX50 automatically powers up via Power
over Ethernet (PoE) and establishes itself on the network.
1.3.1
Pairing the RX50 with the RXV100Hub
Pairing is automatically performed.
To set up automatic pairing, make sure:
You have a version that is version 3.4.6.231 or later. If you don't, upgrade it with firmware
version 3.4.6.231 or later (as shown below).
RXV100Hub and RX50 are in the same network.
You're notified 'Pairing activated':
View also the pairing icon
left corner. After they're paired, log in to the RXV100Hub as Administrator and set RX50 to be its
default audio device.
To upgrade the firmware if necessary:
1.
Open the RX50's Web interface and click Management > Firmware Upgrade.
2.
Navigate to and select the IMG file
3.
Click Submit and then OK.
Note:
The firmware upgrade takes approximately 20 minutes.
•
After the upgrade, restore the RX50 to defaults (MENU>ADMIN>Restore Defaults).
•
[Applies only to customers who want to connect to the RX50 after purchasing the RX50 not
as part of the MTR].
•
Make sure the selected device is the RX50.
To set the RX50 as the default audio device:
1.
After logging in to the RXV100Hub as Administrator (see Section
More and then select
press Yes.
2.
Under Peripherals, select AudioCodes RX50 as 'Microphone for Conferencing', Speaker for
'Conferencing' and 'Default Speaker', and then press Save and Exit.
Deployment Guide
in the top right corner and MTR Audio (instead of Offline) in the top
Settings; enter the Administrator password (default is sfb) and
16
RXV100
1.1.2.2
for details), select
Document #: LTRT-18190
Advertisement
Table of Contents
