Before First Use - IKEA HYGIENISK Manual

ENGLISH
• DELAY and the countdown duration when
the delay start begins.
• An alarm code when the appliance has a
malfunction.
When AutoOpen opens the door,
TimeBeam is off. To check the
remaining time of the running
programme, look at the control
panel display.
Setting mode
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode
while the programme is running.
To enter setting mode, press and hold
simultaneously
seconds.
• The lights related to
are on.
• The display shows the current value
of the first available setting.
How to navigate in setting mode
You can navigate in setting mode using
programme buttons.
A

Before first use

1. Fill the rinse aid dispenser.
2. Open the water tap.
3. Start the Quick 30' programme to
remove any residuals from the
manufacturing process. Do not use
and for about 3
, and
B C
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between
the basic settings and to change their value.
Use OK to enter the selected setting and to
confirm changing its value.
How to change a setting
Make sure the appliance is in setting mode.
1. Use Previous or Next to select the
desired setting.
The display shows the current setting value
(a digit and the dedicated letter).
2. Press OK to enter the setting.
The current setting value flashes.
3. Press Previous or Next to change the
value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously
for about 3 seconds to exit setting
mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
detergent and do not put dishes in the
baskets.
14
and