Check Ethernet Ip Connectivity; Check The Netguardian Ip Address - DPS Telecom NetGuardian Techno Knowledge Paper

Unable to Telnet to NetGuardian
If the connection succeeds, enter a password (default password is "dpstelecom") to log on.
If the Telnet connection fails and you do not see this message, proceed to the next step:
□ Check that the PC has Ethernet IP connectivity to the NetGuardian by
pinging the NetGuardian's IP address. (default = 192.168.1.1)
if the pings do not return, check the Ethernet connectivity for firewalls,
general hardware connections, and IP address settings. Also, ping the gateway to further test connectivity.
□ Check the NetGaurdian IP address
◦ The default IP address (192.168.1.1) most likely will not be compatible with your network
configuration.
◦ Configure the NetGuardian IP address, subnet mask, and gateway for your network.
▪ The best way to check or configure the NetGuardian's IP address settings is to connect
through the front craft port:
▪ Connect your laptop to the front DB9 of the NetGuardian. Use a serial-to-serial or USB-
to-serial cable.
▪ Establish a connection in HyperTerminal (no handshaking, 9600 baud)
 press Enter
 Enter your password (default is "dpstelecom")
Ping the NetGuardian's IP address
If the pings return successfully, proceed to the next step:
12/14/15 3