English: HS3 User's Guide, Chapter 7
Chapter 7 TROUBLESHOOTING
ALARM INDICATIONS AT A GLANCE
Operator Calls
Blinking LED
Alarm
Paper
Alarm
Ink
Alarm
Filter
Alarm
Error
Memory Full
SIMM error
If a recoverable error occurs, the printer indicates an 'operator call' by blinking
the Alarm LED and any of the following LEDs. Clear the error as described
below and press the FF/Cont button to resume printing.
Error
Cover Open
Paper jam
Paper empty
Misfeed
Ink Empty
No Maintenance
cassette or
Maintenance
paper empty
If the following errors occur, the printer indicates the error by blinking the
Alarm LED and printing the error message.
Action
Press the FF/Cont button to print the data remaining in the printer.
Reduce the resolution or reduce the complexity of your document.
Expand the printer memory by fitting a SIMM module.
Check that the optional SIMM is correctly installed.
Note
If the printer does not operate as you expect it to, it is recommended to reset the
printer or turn the printer off and then on again. If you still have problems,
consult your dealer or our authorized service representative.
Action
Close the top cover of the printer.
Clear the paper jam referring to the next section
"PAPER JAMS" and press the FF/Cont button if the
printer does not automatically resume printing.
Load paper in the printer referring to Chapter 2 and
press the FF/Cont button.
Reinstall the paper and press the FF/Cont button.
Ink is empty. Add ink blocks into the printer and
press the FF/Cont button.
Maintenance paper is empty or Maintenance cassette
is not installed correctly. Replace the maintenance
cassette or re-install the cassette.
CHAPTER 7 TROUBLESHOOTING
7–1