Installation Instructions - Neue NDIH 1L949-80 User Manual

Installation instructions

Parts supplied
Drain hose
support (1)
Moisture protection
tape (1) (to prevent
moisture damage to
cabinetry)
Prior to installation
Unpacking and handling
● Check packaging and dishwasher for signs of transport damage. If the
dishwasher is in any way damaged, do not install it. Contact the dealer the
dishwasher was purchased from.
● Disposal of packaging: some of the packaging is recyclable. Check the symbols
and labels and recycle if possible.
● Never lift the dishwasher from the door handle or the top panel. Doing so may
cause damage.
● Always be careful with the hoses and power cord at the back of the dishwasher.
Careful handling will prevent damage and malfunction from squashing, kinking or cuts.
● While installing the dishwasher, check the drain hose is not restricted or kinked.
Connections and services
● Check that the power cord is long enough to reach the outlet. If it isn't, it must be
replaced by a haier authorised technician. Extension cords or multi-outlet power
boards should not be used to connect the dishwasher to the power supply.
● Check that the hoses are long enough to reach the services. If a hose needs
extending, ensure that the extension hose is new and of equal quality and diameter
● The dishwasher should not be connected to a water system where the
temperature exceeds 60
● The dishwasher must not be connected to an undersink high-pressure "push-
through" type hot water system, as damage to the system will result.
4
Inlet hose (1)
Brackets for
plinth (2)
C.
o
Installing the Installation and
fixings (2)
User Instructions
Salt funnel
Ø3.5 x 13mm
screws (10)
Ø4 x 25mm
screws (4)
Ø3.5 x 44mm
screws (4)