1. Manuals
  2. Brands
  3. Neue Manuals
  4. Dishwasher
  5. NDIH 1L949-80
  6. User manual

Neue NDIH 1L949-80 User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

User Manual
Dishwasher
NDIH 1L949-80

Advertisement

Table of Contents
loading

Related Manuals for Neue NDIH 1L949-80

Summary of Contents for Neue NDIH 1L949-80

  • Page 1 User Manual Dishwasher NDIH 1L949-80...

  • Page 2: Table Of Contents

    Thank you for purchasing a Neue product Please read these instructions carefully before using this appliance. The instructions contain important information which will help you get the best out of the appliance and ensure safe and proper installation, use and maintenance.

  • Page 3: Safety And Warnings

    Safety and warnings Your dishwasher has been carefully designed to operate safely during normal dishwashing procedures. Please keep the following instructions in mind when you are using your dishwasher. WARNING Electrical shock hazard Before installing the dishwasher, remove the house fuse or open the circuit breaker. This appliance must be earthed.
  • Page 4 Safety and warnings ● Use only detergents or rinse aid recommended for use in a domestic dishwasher and keep them out of reach of children. ● Check that the detergent dispenser is empty after the completion of each wash program. ●...
  • Page 5 Safety and warnings ● Keep the area around/underneath your appliance free from the accumulation of combustible materials, such as lint, paper, rags and chemicals. Operational safety instructions ● Open the door very carefully if the dishwasher is in operation. There is a risk of being sprayed with hot water.

  • Page 6: Installation Instructions

    Installation instructions Parts supplied Drain hose Inlet hose (1) Installing the Installation and support (1) fixings (2) User Instructions Ø3.5 x 13mm screws (10) Ø4 x 25mm screws (4) Ø3.5 x 44mm Moisture protection Brackets for Salt funnel screws (4) tape (1) (to prevent plinth (2) moisture damage to...
  • Page 7 Installation instructions Product dimensions 3.5-5kg...
  • Page 8 Installation instructions Overall height of product* 816 - 876 Overall width of product (excl. side seals) Overall depth of product (excl. decorative fascia & handle) Depth of plinth 30 - 95 Height from floor to bottom of decorative fascia 100 - 153 Depth of open door (measured from front of chassis) (excl.
  • Page 9 Installation instructions The height of the door panel can reach 731mm. As shown in the figure, the door panel needs to be installed higher than the control panel, height of the batons needs to be 18-20mm. PROFILE See the door panel installation manual for specific dimensions. Batons wood door 18-20...
  • Page 10 Installation instructions Cavity preparation IMPORTANT! To prevent possible steam damage to the cabinetry, ensure that any bare wood surrounding the dishwasher is sealed with an oil-based paint or moisture-proof polyurethane. Apply moisture protection tape to the underside of the benchtop. Back foot of the dishwasher can be adjusted by using...
  • Page 11 Installation instructions Custom door panel preparation Front panel material specifications The front of the dishwasher can be fitted with a front panel with the following specifications: Adequately sealed to withstand moisture (50°C @ 80% RH). Because of it being a hot and wet environment generally, the back and sides of the panel should be completely sealed with a waterproof vapor barrier (ie polyurethane) to prevent damage to the panel.
  • Page 12 Installation instructions Attaching custom door panel 2 mm Insert Ø3.5 x 13mm screws through pilot holes and attach the small slider bracket to panel. Close the door of the dishwasher, then hang the custom panel onto the front of the door.
  • Page 13 Installation instructions Adjust the placement of the door to the correct position. Door balancing: The door balance can be adjusted via two screws accessed through Open the door and remove two holes at the front. screws before replacing Adjust both sides at the them with Ø3.5 x 44mm same time, alternating screws to fix panel into...
  • Page 14 Installation instructions Plinth installation Separate panel 180.9 Centre Mark out the pilot hole locations for each bracket. To establish the height in which the bracket will be fixed, measure the distance from the floor to the lowest hole of the bracket. Remove bracket from the product and plot the location of other holes...
  • Page 15 Installation instructions Continuous panel Note door overhang and swing range relative to height and depth of plinth panel. As the panel is continuous, cutting back panel is likely to be necessary ensure seamless integration. IMPORTANT! Plinth can protrude no more than 90mm out from the dishwasher to ensure that the visibility of the floor light is not obstructed.
  • Page 16 Installation instructions Securing product A Secure to the cabinetry on the sides Secure product to cabinetry through on both sides of the chasis using Ø4 x 25mm screws.
  • Page 17 Installation instructions Optionally secure to the cabinetry above Secure product to the bench through top of the chasis using Ø4 x 25mm screws.
  • Page 18 Installation instructions Plumbing and drainage options. Determine which is more suitable Dishwasher and Ø 38 mm Standpipe If space is limited for fixing, push hose through drain hose support to required height 38mm step 9 min. radius 200 mm...
  • Page 19 Installation instructions Dishwasher using drain hose joiner onto sink trap/waste tee Installer to provide drain hose joiner to suit If space is limited min. 15mm waste tee for fixing, push hose through drain hose support to required height step 9 min.
  • Page 20 Installation instructions Connect inlet hose to cold water min. 10mm 3/4” BSP connector Ensure the supplied rubber No leaks! washer is fitted inside the coupling. Tighten coupling with spanner. Plumbing -- Water inlet connection IMPORTANT! The appliance should be connected to the water main using the new water ●...
  • Page 21 Installation instructions Plug product in Electrical connection The dishwasher must not be connected to the electrical supply while installation is ● being carried out. Ensure all domestic wiring is properly earthed. Check the rating label (located on the left-hand side of the dishwasher’s stainless ●...
  • Page 22 Installation instructions Final checklist To be completed by the installer Check all parts are installed. ● Ensure that all panels and parts thereof are secure and final electrical tests have ● been conducted in accordance with local electrical regulations. Check that the dishwasher is level. If necessary, adjust the levelling feet slightly. ●...

  • Page 23: Product Description

    Product Description Upper basket Rating label Utensil tray Salt container Upper spray arm Detergent dispenser Rinse aid dispenser Lower spray arm Lower basket Filters Cutlery basket...

  • Page 24: Overview Of Programmes

    Overview of programmes 1. ON / OFF button 7. Rinse Aid indicator PROGRAMME SELECT button PROGRAMME indicator Lack Salt and Rinse Aid reset button Additional function indicator Additional function button START DELAY/Status Indicators START DELAY button Salt Aid indicator START / RESET button Additional function button permit to activate Exp function or Multi-tab function.
  • Page 25 Overview of programmes Programmes Programmes Type of food residue Type of load 50°C 298min Universal 60°C 115min Intensive 70°C 130min Prewash 45°C 20min Rapid 45°C 32min 1) Use this programme to quickly rinse the dishes. T his prevents the remaining food to bond on the dishes and bad odours to come out from the appliance.

  • Page 26: Water Softening System

    Water softening system To ensure good washing results,the dishwasher requires soft water.Hard water can be detrimental to the performance of your dishwasher. Over time,glassware washed in hard water will become opaque and dishes will become spotted or covered in a white film.
  • Page 27 Water softening system Using special salt As soon as the low salt indicator is lit on the control panel ,salt should be topped up.Always refill with special salt immediately before switching on the appliance.This ensures that overrun special salt solution is immediately washed out and does not corrode the rinsing tank.

  • Page 28: Using Rinse Aid

    Using rinse aid We highly recommend using liquid rinse aid regularly to get the best drying results.Rinse aid gives a streak-free, sparkling clean look to glass and chinaware. In addition, it prevents metal from tarnishing. When to refill the rinse aid dispenser When rinse aid level becomes low,the rinse and salt indicators will be on to remind you.

  • Page 29: Utensils

    Utensils IMPORTANT! Never put highly absorbent materials, such as sponges and towels in your dishwasher.Do not put dishes or cutlery that have been soiled by tobacco ash, wax, lubricating grease or paint in your dishwasher. Cutlery and silverware All cutlery and silverware should be rinsed immediately after use to prevent tarnishing caused by some foods.

  • Page 30: Loading Utensils

    Loading utensils If the tableware or cookware rack is burnt, scorched,sticky, and other food which is very difficult to removed, it is advisable to soak it for a period of time before washing it or pre-dispose it with a dish cloth or else it will be hard to clean. Remove any large food particles before placing dishes in the dishwasher.
  • Page 31 Loading utensils To adjust the upper rack: IMPORTANT! Before you adjust its height,make sure the basket is empty. Remove: Replace: End Cap Rollers Rail Rail Rollers 1.Fully extend the upper rack and rotate open the two plastic end caps on the front of the rails.
  • Page 32 Loading utensils Cutlery basket Mix spoons with other cutlery ► to prevent them to bond together. Use the grid element in order ► to separate the cutlery. Place Cutlery with ► handles down better washing results. If long items may block the ►...

  • Page 33: How To Make Savings

    How to make savings Tips on how to save money and not damage the environment when using your appliance. Achieve the best use of energy, water, detergent and time by using the recommended maximum load size. Save up to 50% energy by washing a full load instead of 2 half loads.

  • Page 34: Adding Detergent

    Adding detergent IMPORTANT! Only use detergents recommended for automatic dishwashers. Dishwasher detergents are strongly alkaline. They can be extremely dangerous if swallowed. Avoid contact with the skin and eyes and keep children and infirm persons away from the dishwasher when it is open. Check that the detergent dispenser is empty after completion of each wash programme.

  • Page 35: Before First Use

    Before first Use How to Adjust User Preference Settings During the selection of programmes, press and hold for about 5 seconds to enter the user preference settings. User preference settings include Water Softener setting,Buzzer setting,Rinse Aid setting and Memo Mode setting. 1.The appliance is switched on.

  • Page 36: Daily Use

    Daily Use Start a Programme 1. Open the door and Press the ON/OFF button to turn the dishwasher on. 2. Press to select the program you want on the dishwasher control panel. 3. Press to start the programme and close the door. NOTICE If the MEMO MODE YES The appliance remembers the last programme you used.
  • Page 37 Daily Use Cancel a Delayed Start Press the reservation button again to cancel the reservation. Cancel Start Delay / Programme 1. Press the for about 3 second. The start delay is cancelled. The programme is aborted. 2. Start a new programme and a delayed start if desired. CAUTION If a programme will be aborted in the process of washing dishes, the residue of detergent remains on the dishes.

  • Page 38: Care And Cleaning

    Care and cleaning Over time, food residue or limescale deposits may accumulate inside your dishwasher.These may reduce efficiency, and food residue may produce a bad odour. Inspect and clean your dishwasher regularly. IMPORTANT ! Before any cleaning or maintenance, always disconnect the dishwasher from the ●...
  • Page 39 Care and cleaning To remove the drain filter, turn the filter anti-clockwise to release, then lift out. ● Once the drain filter has been removed you can lift the filter plate out. ● Rinse them thoroughly under running water and then replace. ●...
  • Page 40 Care and cleaning Cleaning the centre spray arm To remove the centre spray arm, carefully unscrew its locking nut. ● Rinse the spray arm thoroughly under running water, then refit. ● IMPORTANT ! Make sure you twist the locking nut on the centre spray arm firmly back on the water supply tube.Check that the centre spray arm is firmly locked in place and rotates freely.

  • Page 41: Troubleshooting

    Troubleshooting Many occuring problems could be solved by yourself without specific expertise. In case of a problem please check all shown possibilities and follow below instructions before you contact an after sales service. CAUTION Before maintenance, deactivate the appliance and disconnect the mains plug from ●...
  • Page 42 Troubleshooting Error codes on the display Problem Possible cause Possible solution Open the water tap. Note: Whenever Error is Water tap is closed. s o l v e d s w i t c h o f f t h e appliance and restart the programm.
  • Page 43 Troubleshooting Washing Results are not satisfactory Problem Possible cause Possible solution Filters are clogged. Clean the filters. Make sure that the filters F i l t e r s a r e n o t c o r r e c t l y are correctly assembled and assembled and installed.

  • Page 44: Technical Data

    Troubleshooting / Technical Data Problem Possible cause Possible solution Increase the released quantity Rinse aid dosage is too low. Dry water drop of rinse aid. stains on glasses Q u a l i t y o f r i n s e a i d o r Cleaning product too old;...
  • Page 45 Technical Data Suppliers name or trade mark NEUE Supplier´s model identifier NDIH 1L949-80 Rated capacity in standard -place settings Energy efficiency class 1) Annual energy consumption (AEc) in kWh/year 2) Energy consumption (Et) of the 0.78 standard cleaning cycle in kWh...
  • Page 46 0120503316...

Table of Contents