Martin Alien LED Downlight User Manual page 4

• Luminaires are IP67-rated but do not install them in a location where they may become
immersed in water.
• Refer any service operation not described in this manual to an authorized Martin Service
partner.
PROTECTION FROM BURNS AND FIRE
• Do not operate the devices if the ambient temperature (Ta) exceeds 40° C (104° F).
• Provide free airflow and a minimum clearance of 50 mm (2.0 in.) around the devices and allow
sufficient ventilation to ensure that the ambient temperature around driver units and
transformers does not exceed 40° C (104° F) and the ambient temperature around luminaires
does not exceed 45° C (113° F).
• Allow the devices to cool for 20 minutes before servicing.
• Do not illuminate surfaces less than 0.1 m (4 in.) from the front surface of the luminaire.
• Keep highly flammable materials well away from the devices.
• Do not modify the devices in any way not described in this manual or install other than genuine
Martin parts. Do not stick filters, masks or other materials directly onto LEDs. Use only Martin
approved accessories to mask or modify the light beam.
• Do not attempt to bypass thermostatic switches or fuses. Replace defective fuses with ones of
the specified type and rating only.
• Provide a minimum center-to-center distance of 100 mm (4.0 in.) between Alien LED Downlight
luminaires.
PROTECTION FROM INJURY
• Do not look at LEDs with magnifiers or similar optical instruments that may concentrate the
light output.
• The edges of devices and wing clips may cause cuts if not handled carefully. Protect yourself
with gloves during installation and service.
• Ensure that all external covers, components and installation fittings are securely fastened.
• Block access below the work area and work from a stable platform whenever installing,
servicing or moving the fixture.
• Ensure that all supporting structures, surfaces, fasteners and lifting equipment can bear the
weight of all the devices they are intended to support plus an adequate safety margin, and that
they conform to local building and safety regulations.
• Use a sufficient number of fasteners with sufficient corrosion resistance, dimensions and
strength to mount devices safely. Any nuts used must be self-locking. Install locking washers
under the heads of fasteners.
Disposing of this product
Martin™ products are supplied in compliance with Directive 2002/96/EC of the
European Parliament and of the Council of the European Union on WEEE (Waste
Electrical and Electronic Equipment), as amended by Directive 2003/108/EC, where
applicable.
Help preserve the environment! Ensure that this product is recycled at the end of its
life. Your supplier can give details of local arrangements for the disposal of Martin
products.