Table of Contents
Advertisement
Straight guide (Accessory)
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Attach the guide plate to the straight guide with the bolt
and the wing nut.
1
2
3
4
► 1 . Bolt 2. Guide plate 3. Straight guide 4. Wing nut
Remove the chip deflector.
1
2
3
► 1 . Clamp screw (A) 2. Straight guide 3. Wing nut 4. Base
Attach the straight guide with the clamp screw (A).
Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance (A) between the side of the workpiece and the cutting
position is too wide for the straight guide, or if the side of the work-
piece is not straight, the straight guide cannot be used. In this case,
firmly clamp a straight board to the workpiece and use it as a guide
against the trimmer base. Feed the tool in the direction of the arrow.
A
Circular work
► 1 . Wing nut 2. Guide plate 3. Straight guide
4. Center hole 5. Bolt
Circular work may be accomplished if you assemble the
straight guide and guide plate as shown in the figures.
Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit) are
as follows:
Min.: 70 mm
Max.: 221 mm
For cutting circles between 70 mm and 121 mm in radius.
For cutting circles between 121 mm and 221 mm in
radius.
4
► 1 . Wing nut 2. Guide plate 3. Straight guide
4. Center hole 5. Bolt
NOTE:
•
Circles between 172 mm and 186 mm in radius
cannot be cut using this guide.
6 ENGLISH
1
4
5
1
4
5
2
3
2
3
Advertisement
Table of Contents
